User Manual

Configuring System Information
44
M6100 Web Management User Guide
4. Use Response Timeout (secs) to specify the amount of time, in seconds, to wait for a
response to a DNS query. This timeout ranges from 0 to 3600. The default value is 3.
5. T
o specify the DNS server to which the switch sends DNS queries, enter an IP address in
standard IPv4 dot notation in the DNS Server Address and click Add. The server appears
in the list below. You can specify up to eight DNS servers. The precedence is set in the
order created.
6. T
o remove a DNS server from the list, select the check box next to the server you want to
remove and click Delete. If no DNS server is specified, the check box is global and will
delete all the DNS servers listed.
7. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
8. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
9. Click Add to add the specified DNS Server to the List of DNS Servers. Configuration
changes take ef
fect immediately.
10. Click Delete to delete the specified DNS Server from the list of DNS Servers. If no DNS
Server is specified then it will delete all the DNS Servers
DNS Server Configuration
The following table displays DNS Server Configuration information.
Table 20.
Field Description
Serial No The sequence number of the DNS server.
Preference Shows the preference of the DNS Server. The
preference is determined by the order they were
entered.
DNS Server Configuration
Host Configuration
Use this page to manually map host names to IP addresses or to view dynamic DNS
mappings.
To access this page, click System  Management  DNS  Host Configuration.