User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Configuring Switching Information
177
M6100 Web Management User Guide
• MLD Snooping Configuration on page 177
• MLD Snooping Interface Configuration on page 178
• MLD VLAN Configuration on page 179
• Multicast Router Configuration on page 179
• Multicast Router VLAN Configuration on page 180
• MLD Snooping Querier Configuration on page 180
• MLD Snooping Querier VLAN Configuration on page 181
MLD Snooping Configuration
Use this menu to configure the parameters for MLD Snooping, which is used to build
forwarding lists for multicast traffic. Note that only a user with Read/Write access privileges
may change the data on this screen.
To access the MLD Snooping Configuration page, click Switching
Multicast MLD
Snooping
Configuration.
1. Use MLD Snooping Admin Mode to select the administrative mode for MLD Snooping
for the switch. The default is Disable.
2. Select the Proxy Querier Mode to Enable or Disable MLD Proxy Querier on the system. If
it is disabled, then MLD Proxy query with source IP 0::0 is not sent in response to an MLD
leave packet. If it is enabled, then MLD Proxy queries are sent.
The default value is Enable.
3. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. Click Update to update the page with the latest information on the switch.
Table 73 describes the non-configurable MLD Snooping Configuration fields.