User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Configuring System Information
122
M6100 Web Management User Guide
1. Use Admin Mode to specify whether the ISDP Service is to be Enabled or Disabled.
The default value is Enabled.
2. Use T
imer to specify the period of time between sending new ISDP packets. The range is 5
to 254 seconds. Default value is 30 seconds.
3. Use Hold T
ime to specify the hold time for ISDP packets that the switch transmits. The hold
time specifies how long a receiving device should store information sent in the ISDP packet
before discarding it. The range 10 to 255 seconds. Default value is 180 seconds.
4. Use V
ersion 2 Advertisements to enable or disable the sending of ISDP version 2 packets
from the device. The default value is Enabled.
The following table describes the ISDP Basic Global Configuration fields.
Table 65. ISDP Basic Global Configuration
Field Description
Neighbors table last time changed Specifies if
Device ID Displays the device ID of this switch.
Device ID format capability Displays the device ID format capability.
Device ID format Displays the device ID format.
Advanced
From the Advanced link, you can access the following pages:
• Global Configuration on page 123
• Interface Configuration on page 123
• ISDP Neighbor on page 124
• ISDP Statistics on page 125