User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Configuring System Information
104
M6100 Web Management User Guide
Table 55. SNMP Supported MIBs
Field Description
Name The RFC number if applicable and the name of the
MIB.
Description The RFC title or MIB description.
SNMP V3
This page provides the configuration information for SNMP v3.
From the SNMP V3 link, you can access the following pages:
• User Configuration on page 104
User Configuration
To access this page, click System SNMP SNMP V3 User Configuration. A screen
similar to the following is displayed.
To configure SNMPv3 settings for the user account:
1. Use User Name to specify the user account to be configured.
2. SNMP v3
Access Mode - Indicates the SNMPv3 access privileges for the user account.
The admin account always has 'Read/Write' access, and all other accounts have 'Read
Only' access.
3. Use Authentication Protocol to specify the SNMPv3
Authentication Protocol setting for the
selected user account. The valid Authentication Protocols are None, MD5 or SHA:
• If you select None, the user will be unable to access the SNMP data from an SNMP
browser
.
• If you select MD5 or SHA, the user login password will be used as the SNMPv3
authentication password, and you must therefore specify a password, and it must be
eight characters long.