User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Configuring System Information
88
M6100 Web Management User Guide
To display Power Redundancy:
1. Click System > Chassis >
Advanced > Chassis Power Configuration.
Figure 18. Power Redundancy
The following table describes the non-configurable Power Redundancy data that is
displayed.
Table 45. Power Redundancy
FIeld Description
N+1 Configuration Power redundancy configuration.
Possible values are Enable and
Disable.
N+1 Active Displays whether power supply N+1
redundancy is active on the chassis.
Number of PSU Total number of active PSUs in
chassis.
Effective Power Effective number of PSUs in the
chassis after factoring N+1 active
state. V
alue will be one less than
Number of PSU when N+1 is active
on the chassis.
Current Power Consumption Displays amount of power required by blade (excluding PoE
power) in watts.
Blade Power Required Displays amount of power required by blade (excluding PoE
power) in watts.
Blade Status Displays blade status. The possible values are:
• OK
• Booting up
• Bootup Failed
• Thermal Shutdown
• SW Power Down
• Not Enough Power
• Unknown Blade
• Absent
Field Description