User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Configuring System Information
70
M6100 Web Management User Guide
• Other - If this option is selected, the UDP Port Other Value is enabled. This option
permits the user to enter their own UDP port in UDP Port Other Value.
4. Use UDP Port Other V
alue to specify UDP Destination Port that lies between 0 and 65535.
5. Use Discard to enable/disable dropping of matched packets. Enable can be chosen only
when a user enters 0.0.0.0 IP address. Discard mode can be set to Disable when user adds
a new entry with a non-zero IP address.
6. Click Add to create an entry in UDP Relay
Table with the specified configuration.
7. Click Apply to send the updated configuration to the switch. Configuration changes take
ef
fect immediately.
8. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
9. Click Delete to remove all entries or a specified one from UDP Relay Interface Configuration
T
able.
10. Click Update to update the page with the latest information on the switch.
The following table describes the UDP Relay Interface Configuration fields.
Table 34.
Field Description
Hit Count Show the number of UDP packets hitting the UDP
port.
UDP Relay Interface Configuration
DHCPv6 Server
The System > Services > DHCPv6 Server navigation contains links to the following web
pages that configure and display DHCPv6 data:
• DHCPv6 Server Configuration
• DHCPv6 Pool Configuration on page 71
• DHCPv6 Prefix Delegation Configuration on page 73
• DHCPv6 Interface Configuration on page 73
• DHCPv6 Bindings Information on page 74
• DHCPv6 Server Statistics on page 75
DHCPv6 Server Configuration
Use this page to configure the Dynamic Host Configuration Protocol for IPv6 (DHCPv6)
server settings on the device. The device can act as a DHCPv6 server or DHCPv6 relay
agent to help assign network configuration information to IPv6 clients.
To display the DHCP Server Configuration page, click System > Services > DHCPv6 Server
> DHCPv6 Server Configuration.
A screen similar to the following is displayed.