User Manual

Managing Device Security
448
M6100 Web Management User Guide
1. Use Promiscuous Primary VLAN to set the Primary VLAN ID for Promiscuous
Association Mode. The range of the VLAN ID is 2-4093.
2. Use Promiscuous Secondary VLAN ID(s) to set the Secondary VLAN ID List for
Promiscuous
Association Mode. This field can accept single VLAN ID or range of VLAN IDs
or a combination of both in sequence separated by ','. You can specify individual VLAN ID.
Eg: 10 You can specify the VLAN range values separated by a '-'. E.g. 10-13 You can
specify the combination of both separated by ','. Eg: 12,15,40-43,1000-1005,2000 The range
of the VLAN ID is 2-4093.
Note: The VLAN ID List given in this control will replace the configured
Secondary VLAN list in the association.
3. Click Delete to delete the IP subnet-based VLAN from the switch.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. If you make changes to the page, click Apply to apply the changes to the system.
Configuration changes take ef
fect immediately.
Field Description
Interface Select the physical or LAG interface for which you
want to display or configure data.
Operational VLAN(s) Displays the operational VLAN(s).
Storm Control
A broadcast storm is the result of an excessive number of broadcast messages
simultaneously transmitted across a network by a single port. Forwarded message
responses can overload network resources and/or cause the network to time out.
The switch measures the incoming broadcast/multicast/unknown unicast packet rate per port
and discards packets when the rate exceeds the defined value. Storm control is enabled per
interface, by defining the packet type and the rate at which the packets are transmitted.
The Storm Control link contains links to the following pages: