User Manual
Table Of Contents
- M6100 Web Management User Guide
- Contents
- 1. Getting Started
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Routing
- 5. Configuring Quality of Service
- 6. Managing Device Security
- 7. Monitoring the System
- 8. Maintenance
- 9. Help
- A. Default Settings
- B. Configuration Examples
- C. Notification of Compliance
Routing
347
M6100 Web Management User Guide
Table 140. Multicast IGMP Proxy Membership
Field Description
Proxy Interface Displays the interface on which IGMP proxy is enabled.
Group IP Displays the IP multicast group address.
Source Hosts This parameter shows source addresses which are members of this multicast
address.
Last Reporter The IP address of the source of the last membership report received for the
IP Multicast group address on the IGMP Proxy interface.
Up Time The time elapsed since this entry was created.
Expiry Time This parameter shows expiry time interval against each source address
which is a member of this multicast group.
This is the amount of time after
which the specified source entry is aged out.
State The state of the host entry. A Host can be in one of the state. Non-member
state - does not belong to the group on the interface. Delaying member state
- host belongs to the group on the interface and report timer running.
The
report timer is used to send out the reports. Idle member state - host belongs
to the group on the interface and no report timer running.
Filter Mode The group filter mode (Include/Exclude/None) for the specified group on the
IGMP Proxy interface.
Number of Sources The number of source hosts present in the selected multicast group.
Multicast PIM
Protocol-Independent Multicast (PIM) is a standard multicast routing protocol that provides
scalable interdomain multicast routing across the Internet, independent of the mechanisms
provided by any particular unicast routing protocol.
From the Routing > Multicast > PIM link, you can access the following pages:
• PIM Global Configuration on page 347
• PIM SSM Configuration on page 348
• PIM Interface Configuration on page 349
• PIM Neighbor on page 350
• PIM Candidate Rendezvous Point Configuration on page 350
• PIM Bootstrap Router Candidate Configuration on page 351
• PIM Static Rendezvous Point Configuration on page 352
PIM Global Configuration
To display the Multicast PIM Global Configuration page, click Routing Multicast PIM
Global Configuration. The following page is displayed.