User Manual

Routing
261
M6100 Web Management User Guide
a non-existent access list, all routes are permitted. The valid values for Access List IDs are
0 to 199. When used for route filtering, the only fields in an access list that get used are:
• Source IP Address and netmask
• Destination IP Address and netmask
• Action (permit or deny)
All other fields (such as source and destination port, precedence, tos, etc.) are ignored.
The source IP address is compared to the destination IP address of the route. The source
IP netmask in the access list rule is treated as a wildcard mask, indicating which bits in
the source IP address must match the destination address of the route.
Note: A 1 in the mask indicates a do not care in the corresponding address
bit.
When an access list rule includes a destination IP address and netmask (an extended
access list), the destination IP address is compared to the network mask of the
destination of the route. The destination netmask in the access list serves as a wildcard
mask, indicating which bits in the route's destination mask are significant for the filtering
operation.
5. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Table 98, RIP Route Redistribution Summary describes the RIP Route Redistribution
non-configurable data that is displayed.
Table 98. RIP Route Redistribution Summary
Field Description
Source Protocol The source route to be redistributed by RIP. The valid values are:
• Connected
• Static
• OSPF
Redistribute Mode The route-redistribution mode for a particular source protocol. By default this
is disabled.
Metric The metric of redistributed routes for the given source route. The field
displays 0 when the metric is not configured.
Distribute List The Access List that filters the routes to be redistributed by the Destination
Protocol. The field displays 0 when not configured.
The following list of redistributed routes is valid when OSPF is selected as source. The list may include one or more
of:
Match Internal Sets Internal OSPF Routes to be redistributed.