Quick Start Manual

Chapter 100-240VAC PSU XCM88PS1 Installation Note | 7
8800 Series 100-240VAC PSU XCM88PS1 Installation Guide
Installing an 8800 Series 100-240VAC PSU
CAUTION:
Make sure that the PSU circuit is not overloaded. Use proper over-current
protection, such as a circuit-breaker, to prevent over-current conditions.
To install an 8800 Series 100-240VAC PSU:
1. Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to
the ground receptacle, at the top left corner of the switch front panel.
2. Verify that the PSU is right side up and the locking handle is open as shown in the following
figure:
Figure 1. 8800 Series 100-240VAC PSU with locking handle open
3. Carefully slide the 8800 Series 100-240VAC PSU all the way into the power supply bay (see
the following figure).
CAUTION:
Do not slam the 8800 Series 100-240VAC PSU into the switch backplane.
Use the locking handle to secure the 8800 Series 100-240VAC PSU into
the switch.