Quick Start Manual

6 | Chapter 100-240VAC PSU XCM88PS1 Installation Note
8800 Series 100-240VAC PSU XCM88PS1 Installation Guide
Power Supply Cords
The following power supply cords are provided in the package with the PSU:
Each power cord is enclosed in a plastic wrapper with it’s model number and product name
on it. Locate the correct cord based on your region.
If you use a 110 V AC power supply cord, the maximum DC output power of the PSU is 700
W. If you use a 220V AC power supply cord the maximum DC output power of the PSU is
1200 W.
All power supply cords must meet the following requirements:
• The power supply cord must be agency-certified for country of use, and rated at 10A by
in-country regulatory authority.
• The power supply cord must have an IEC 320 C13, 90-degree angle plug to connect to
the IEC320 C14 connector on the power supply.
• The power supply cord must have an appropriately rated and approved wall plug
applicable to the country of installation.
• For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
2
) minimum; over
6 feet, the minimum wire size is 16 AWG (1.0 mm
2
).
WARNING!
Make sure that the source outlet is properly grounded before
plugging the AC power cord into the 8800 Series 100-240VAC PSU.
Pre-Installation Requirements
You need the following tools and equipment to install or remove a 8800 Series 100-240VAC PSU:
• ESD-preventive wrist strap
• Power supply cord
• Thermal protective gloves (required for removal; PSU may be hot to touch)
Table 1. Power supply cords
Model Product Name Region
10041 Power cord, 10A, NEMA 5-15P, IEC320-C13, Right Angle North America
10042 Power cord, 12A, JISC8303, IEC320-C13, Right Angle Japan
10043 Power cord, 10A, CEE 7/7, IEC320-C13, Right Angle Europe
10044 Power cord, 10A, BS1363, IEC320-C13, Right Angle Great Britain
10046 Power cord, 10A, NAS3112, IEC320-C13, Right Angle Australia