Owner's Manual

Appendix D. Supported Protocols, MIBs, and Standards | 915
NETGEAR 8800 User Manual
NETGEAR-TRAP-MIB
This MIB defines the following NETGEAR-specific SNMPv1 traps generated by NETGEAR
devices.
Table/Group Supported Variables Comments
netgearFdbMacFdbTable All objects Not supported
netgearFdbIpFdbTable All objects Support SNMP get and get next
operations only.
netgearFdbPermFdbTable All objects
netgearFdbMacExosFdbTable netgearFdbMacExosFdbEntry A table that contains information
about the hardware MAC FDB table.
Supported only on switches running
XCM8800. Support SNMP get and
get next operations only.
netgearFdbMacFdbCounterTable All objects Support SNMP get and get next
operations only.
Trap Comments
netgearMACTrackingAdd The specified MAC address was added to the FDB on the mentioned
port and VLAN.
netgearMACTrackingDel The specified MAC address was deleted from the FDB on the
mentioned port and VLAN.
netgearMACTrackingMove The specified MAC address was moved from the previous port to the
new port on the specified VLAN.
Trap Comments
netgearOverheat The on board temperature sensor has reported a overheat condition.
The system shutdowns until the unit has sufficiently cooled such that
operation may begin again. A cold start trap is issued when the unit
has come back on line.
netgearFanFailed One or more of the cooling fans inside the device has failed. A fanOK
trap will be sent once the fan has attained normal operation.
netgearFanOK A fan has transitioned out of a failure state and is now operating
correctly.
netgearInvalidLoginAttempt A user attempted to log into console or by telnet but was refused
access due to an incorrect username or password.
netgearPowerSupplyGood One or more previously bad sources of power to this agent has come
back to life without causing an agent restart.