Owner's Manual

914 | Appendix D. Supported Protocols, MIBs, and Standards
NETGEAR 8800 User Manual
NETGEAR-OSPF-MIB
The following tables, groups, and variables are supported in this MIB.
NETGEAR-FDB-MIB
The following tables, groups, and variables are supported in this MIB.
netgearTargetAddrExtUseEvent
Comm
This object is used only when
sending RMON alarms as SNMPv3
traps. When it is set to TRUE and an
RMON risingAlarm or fallingAlarm is
being sent for an event, then the
eventCommunity in the RMON event
table is compared to the
snmpTargetAddrName in the
snmpTargetAddrTable. The alarm is
sent to the target only when the two
are the same. This behavior is
exhibited only when the
snmpTargetParamsMPModel
corresponding to the target indicates
an SNMPv3 trap. For SNMPv1/v2c
traps, the community in the RMON
trapDestTable is used for the
comparison, which is the 'regular'
method, as per the standards. When
this object is set to FALSE, then the
RMON alarm (if being sent as an
SNMPv3 trap) is sent without using
the event community for any
comparison.
netgearTargetAddrExtTrapSrcIp This object contains the source IP
address from which traps have to be
sent out. If this object is assigned an
IP address that does not belong to
the switch, an error is thrown.
netgearUsm3DESPrivProtocol Supported from XCM8800 12.3
netgearUsmAesCfb192Protocol Supported from XCM8800 12.3
netgearUsmAesCfb256Protocol Supported from XCM8800 12.3
Table/Group Supported Variables Comments
netgearOspfInterfaceTable All objects This table contains NETGEAR specific
information about OSPF interfaces.
Table/Group Supported Variables Comments