Owner's Manual

906 | Appendix D. Supported Protocols, MIBs, and Standards
NETGEAR 8800 User Manual
NETGEAR-PORT-MIB
The following tables, groups, and variables are supported in this MIB.
netgearVlanOpaqueControlTable All objects For all tables in this MIB that contain
objects with RowStatus semantics, the
only values supported are:

{active, createAndGo, destroy}.
New to XCM8800:
netgearVlanOpaqueControlTable is a
write only table and cannot be used to
read. This is used to add/delete ports
on a VLAN.
netgearVlanStackTable All objects Not supported.
netgearVlanL2StatsTable All objects Not supported. 
This table contains per VLAN
information about the number of
packets sent to the CPU, the number
of packets learnt, the number of Igmp
control packets snooped and the
number of Igmp data packets switched.
This is the same information that is
available via the CLI command 'show
l2stats'.
Table/Group Supported Variables Comments
netgearPortLoadshareTable All objects Not supported
netgearPortSummitlinkTable All objects Not supported.
netgearPortLoadshare2Table netgearPortLoadshare2Entry A table of bindings between
a master port and its
load-sharing slaves:
create/delete entries here to
add/delete a port to/from a
load-sharing group. Default
is empty table. There are
restrictions on what row
creates will be accepted by
each device.
netgearPortLoadshare2MasterIfIndex The ifIndex value which
identifies the port controlling
a load-sharing group of ports
which includes
netgearPortLoadshareSlaveI
fIndex.
Table/Group Supported Variables Comments