Owner's Manual

Appendix D. Supported Protocols, MIBs, and Standards | 905
NETGEAR 8800 User Manual
netgearVlanIfStatus The status column for this VLAN
interface

This object can be set to: active (1);
createAndGo(4); createAndWait(5);
destroy(6). The following values may
be read: active(1); notInService(2);
notReady(3).
netgearVlanIfIgnoreStpFlag Not supported.
netgearVlanIfIgnoreBpduFlag Not supported.
netgearVlanIfLoopbackModeFlag Setting this object to true causes
loopback mode to be enabled on this
VLAN."
netgearVlanIfVlanId The VLAN ID of this VLAN."
netgearGlobalMappingTable Not supported
netgearVlanEncapsTable Not supported
netgearVlanIpTable All objects For all tables in this MIB that contain
objects with RowStatus semantics, the
only values supported are:
{active, createAndGo, destroy}.
netgearVlanProtocolTable Not supported
netgearVlanProtocolBindingTable Partial For all tables in this MIB that contain
objects with RowStatus semantics, the
only values supported are:

{active, createAndGo, destroy}.
New to XCM8800: Association of a
protocol filter and VLAN.
netgearVlanProtocolVlanTable Not supported
netgearVlanProtocolDefTable Partial For all tables in this MIB that contain
objects with RowStatus semantics, the
only values supported are:

{ active, createAndGo, destroy }
New to XCM8800: This is a new table
introduced to add a protocol filter with
etype values during creation of filter
itself.
netgearVlanOpaqueTable All objects This is a read only table. For adding
ports to a VLAN or deleting ports to a
vlan, use
netgearVlanOpaqueControlTable.
Table/Group Supported Variables Comments