Owner's Manual

886 | Appendix D. Supported Protocols, MIBs, and Standards
NETGEAR 8800 User Manual
dot1agCfmMepCcmLtmPriority Supported as read only. The
priority value for CCMs and
LTMs transmitted by the MEP.
Currently Config in CLI is not
supported. default value 0 will
be returned.
dot1agCfmMepMacAddress Mac address of the MEP. In
netgear device switch mac will
be returned.
dot1agCfmMepLowPrDef Supported as read only. An
integer value specifying the
lowest priority defect that is
allowed to generate Fault
Alarm. Currently Config in CLI
is not supported: default
VLAN macRemErrXon will be
returned.
dot1agCfmMepFngAlarmTime Supported as read only. The
time that defects must be
present before a Fault Alarm
is issued. Currently Config in
CLI is not supported: default
value 2.5 seconds will be
returned.
dot1agCfmMepFngResetTime Supported as read only. The
time that defects must be
absent before resetting a
Fault Alarm. Currently Config
in CLI is not supported:
default value 10 seconds will
be returned.
dot1agCfmMepHighestPrDefect The highest priority defect that
has been present. Will have
any one of the following
values:
none(0)
defRDICCM(1) 
defMACstatus(2)
defRemoteCCM(3)
defErrorCCM(4)
defXconCCM(5)
Table/Group Supported Variables Comments