Owner's Manual

Appendix D. Supported Protocols, MIBs, and Standards | 885
NETGEAR 8800 User Manual
dot1agCfmMaNetCcmInterval Supported as read only.
Transmission interval between
CCMs to be used by all MEPs
in the MA.
dot1agCfmMaNetRowStatus The status of the row. The
writable columns in a row
cannot be changed if the row
is active. All columns must
have a valid value before a
row can be activated.
dot1agCfmMepTable dot1agCfmMdIndex Maintenance Domain Index.
dot1agCfmMaIndex Maintenance Association
Index.
dot1agCfmMepIdentifier A small integer, unique over a
given Maintenance
Association identifying a
specific Maintenance
Association end point.
dot1agCfmMepIfIndex Supported as read only.
Interface Index of the interface
bridge port.
dot1agCfmMepDirection Supported as read only. The
direction in which the MEP
faces on the bridge port.
dot1agCfmMepPrimaryVid Supported as read only. VID
of the MEP.
dot1agCfmMepActive Supported as read only.
Administrative state of the
MEP.
dot1agCfmMepFngState Current state of the MEP Fault
Notification Generator State
Machine. Can have any one
of the following values:
fngReset (1),
fngDefect (2),
fngReportDefect (3),
fngDefectReported (4),
fngDefectClearing (5)
dot1agCfmMepCciEnabled Supported as read only. If set
to true, the MEP will generate
CCM.
Table/Group Supported Variables Comments