Owner's Manual

Appendix D. Supported Protocols, MIBs, and Standards | 881
NETGEAR 8800 User Manual
RFC 5601 (PW-STD-MIB)
The following tables, groups, and variables are supported in this MIB. All tables and variables
of this MIB are supported as read only. The comments here are abbreviated versions of the
description in the RFC documentation.
Table/Group Supported Variables Comments
pwTable pwIndex A unique index for the conceptual row identifying a PW
within this table.
pwPeerAddr This object contains the value of the peer node address
of the PW/PE maintenance protocol entity. This object
SHOULD contain a value of all zeroes if not applicable
(pwPeerAddrType is 'unknown').
pwID Pseudowire identifier. If the pwOwner object is
'pwIdFecSignaling' or 'l2tpControlProtocol', then this
object is signaled in the outgoing PW ID field within the
'Virtual Circuit FEC Element'. For other values of
pwOwner, this object is not signaled and it MAY be set
to zero.
pwLocalCapabAdvert If a maintenance protocol is used, it indicates the
capabilities the local node will advertise to the peer.
pwRemoteGroupID This object is obtained from the Group ID field as
received via the maintenance protocol used for PW
setup. Value of zero will be reported if not used. Value
of 0xFFFFFFFF shall be used if the object is yet to be
defined by the PW maintenance protocol.
pwOutboundLabel The PW label used in the outbound direction (i.e.,
toward the PSN). It might be set manually if pwOwner is
'manual'; otherwise, it is set automatically.
pwInboundLabel The PW label used in the inbound direction (i.e.,
packets received from the PSN). It may be set manually
if pwOwner is 'manual'; otherwise, it is set
automatically.
pwCreateTime The value of sysUpTime at the time this PW was
created.
pwUpTime Specifies the time since last change of pwOperStatus to
Up(1).
pwLastChange The value of sysUpTime at the time the PW entered its
current operational state. If the current state was
entered prior to the last re-initialization of the local
network management subsystem, then this object
contains a zero value.
pwAdminStatus The desired operational status of this PW. This object
MAY be set at any time.