Owner's Manual

Appendix D. Supported Protocols, MIBs, and Standards | 873
NETGEAR 8800 User Manual
SNMPv3 MIBs
The XCM8800 SNMP stack fully supports the SNMPv3 protocol and therefore implements
the MIBs in the SNMPv3 RFCs. Specifically, the MIBs in the following RFCs are fully
supported.
• RFC 3410 – Introduction and Applicability Statements for Internet-Standard Management
Framework
• RFC 3411 – An Architecture for Describing Simple Network Management Protocol
(SNMP) Management Frameworks
• RFC 3412 – Message Processing and Dispatching for the Simple Network Management
Protocol (SNMP)
• RFC 3413 – Simple Network Management Protocol (SNMP) Applications.
• RFC 3414 – User-based Security Model (USM) for version 3 of the Simple Network
Management Protocol (SNMPv3)
• RFC 3415 – View-based Access Control Model (VACM) for the Simple Network
Management Protocol (SNMP)
• RFC 2576 – Coexistence between Version 1, Version 2, and Version 3 of the
Internet-standard Network Management Framework
• RFC 3826 - The Advanced Encryption Standard (AES) Cipher Algorithm in the SNMP
User-based Security Model
RFC 2737 (ENTITY-MIB)
The following tables, groups, and variables are supported in this MIB.
pimSourceLifetime State Refresh feature is not supported,
so these variables are set to defaults.
pimStateRefreshInterval
pimStateRefreshLimitInterval
pimStateRefreshTimeToLive
PIM Traps pimNeighborLoss Not supported.
Table/Group Supported Variables Comments
entityPhysicalTable entPhysicalndex
entPhysicalDescr
entPhysicalVendorType
entPhysicalContainedIn
entPhysicalClass
Table/Group Supported Variables Comments