Owner's Manual

864 | Appendix D. Supported Protocols, MIBs, and Standards
NETGEAR 8800 User Manual
RFC 1215
This MIB defines an SMI for SNMPv1 traps, and some traps themselves. Of these, the
following are supported.
RFC 1493 (BRIDGE-MIB) and draft-ietf-bridge-rstpmib-03.txt
The BRIDGE-MIB has been augmented with draft-ietf-bridge-rstpmib-03.txt for 802.1w
support. Objects below that are defined in the latter are marked as such.
IfTestTable Not supported
ifRcvAddressTable All objects The ‘ifRcvAddressTable’ is supported read-only. Also,
only entries for physical ports will appear in it.
snmpTraps linkDown
linkUp
Traps Comments
coldStart The system cannot distinguish between a cold and warm reboot, so the
warmStart trap is always sent.
warmStart
authenticationFailure
linkDown
linkUp
Table/Group Supported Variables Comments
dot1dBase group scalars dot1dBaseBridgeAddress
dot1dBaseNumPorts This object returns the number of ports in
STP domain ‘s0’, not the total number of
ports on the switch.
dot1dBaseType
dot1dBasePortTable Partial dot1dBasePortIfIndex is supported.
dot1dBasePortCircuit will always have the
value { 0 0 } since there is a one to one
correspondence between a physical port
and its ifIndex.
dot1dBasePortDelayExceededDiscards
and dot1dBasePortMtuExceededDiscards
are not supported and always return 0.
Table/Group Supported Variables Comments