Owner's Manual

788
Chapter 30. vMAN (PBN) 8800 Chassis Switch
disable dot1p examination ports [all | <port_list>]
Note: See Chapter 15, QoS for information on configuring and displaying
the current 802.1p and DiffServ configuration for the S-tag 802.1p
value.
Displaying vMAN Information
You can display the vMAN (PBN) configuration and any associated EAPS domains by issuing
the following command:
show vman {<vman_name> {ipv6} | etherType | detail {ipv6}}
You can also display vMAN information, as well as all the VLANs, by issuing the show ports
information detail
command.
To display information on all vMANs, use the following command:
show vman
To display information on a specific vMAN, use the following command:
show vman <vman_name>
To display the ethertype for a vMAN, use the following command:
show vman ethertype
Configuration Examples
This section provides the following examples:
• vMAN Example, NETGEAR 8810 on page 788
• Multiple vMAN Ethertype Example on page 790
vMAN Example, NETGEAR 8810
The following example shows the steps to configure a vMAN (PBN) on the NETGEAR 8810
switch shown in
Figure 99.