Owner's Manual

740 | Chapter 27. Multicast Routing and Switching
NETGEAR 8800 User Manual
multicast static route 58.1.10.0/24 is shown as UP only when the OSPF route is available to
reach the network 58.1.10.0/24.
Static routes are stored in the switch configuration and can be viewed with the show
configuration
command. Static multicast routes that do not include protocol information are
displayed using the
configure iproute command format, even if they were created using the
configure ipmroute command. Static routes that are created with a protocol field are
displayed using the
configure ipmroute command format.
PIM Configuration Examples
This section provides the following examples:
• PIM-DM Configuration Example on page 740
• PIM-SM Configuration Example on page 742
• PIM-SSM Configuration Example on page 743
• PIM Snooping Configuration Example on page 744
PIM-DM Configuration Example
In Figure 85, the system labeled IR 1 is configured for IP multicast routing, using PIM-DM.