Owner's Manual

686 | Chapter 24. OSPF
NETGEAR 8800 User Manual
configure ospf vlan Chi_160_26_26 priority 10
configure ospf vlan HQ_10_0_2 priority 5
configure ospf vlan HQ_10_0_3 priority 5
enable ospf
Configuration for IR1
The router labeled IR1 has the following configuration:
configure vlan HQ_10_0_1 ipaddress 10.0.1.2 255.255.255.0
configure vlan HQ_10_0_2 ipaddress 10.0.2.2 255.255.255.0
enable ipforwarding
configure ospf add vlan all area 0.0.0.0
configure ospf area 0.0.0.0 priority 10
enable ospf
Note: In OSPF edge mode, the VLAN priority is “0” and cannot be set.
(See
OSPF Edge Mode on page 674.) When the license is upgraded
to a Core license, the VLAN priority of “0” needs to be reset in order
to participate in DR/BDR election.
Displaying OSPF Settings
You can use a number of commands to display settings for OSPF. To show global OSPF
information, use the
show ospf command with no options.
To display information about one or all OSPF areas, use the following command:
show ospf area {<area-identifier>}
The detail option displays information about all OSPF areas in a detail format.
To display information about OSPF interfaces for an area, a VLAN, or for all interfaces, use
the following command:
show ospf interfaces {vlan <vlan-name> | area <area-identifier> | enabled}
The detail option displays information about all OSPF interfaces in a detail format.
XCM8800 provides several filtering criteria for the show ospf lsdb command. You can
specify multiple search criteria, and only those results matching all of the criteria are
displayed. This allows you to control the displayed entries in large routing tables.
To display the current link-state database, use the following command: