Owner's Manual

646 | Chapter 21. IPv6 Unicast Routing
NETGEAR 8800 User Manual
Relative Route Priorities
Table 66 lists the relative priorities assigned to routes depending on the learned source of the
route.
Note: Although these priorities can be changed, do not attempt any
manipulation unless you are expertly familiar with the possible
consequences.
To change the relative route priority, use the following command:
configure iproute ipv6 priority [ripng | blackhole | icmp | static |
ospfv3-intra | ospfv3-inter | ospfv3-as-external | ospfv3-extern1 |
ospfv3-extern2 | isis-leve1-1 | isis-level-2 | isis-level-1-external |
isis-level-2-external] <priority> {vr <vrname>}
Configuring IP Unicast Routing
The following sections describe IP unicast routing tasks:
• Configuring Basic IP Unicast Routing on page 647
• Managing Neighbor Discovery on page 647
• Managing Router Discovery on page 649
• Managing Tunnels on page 650
• Verifying the IP Unicast Routing Configuration on page 651
Table 66. Relative Route Priorities
Route Origin Priority
Direct 10
BlackHole 50
Static 1100
ICMP 1200
OSPF3Intra 2200
OSPF3Inter 2300
RIPng 2400
OSPFv3 ASExt 3100
OSPFv3 Extern1 3200
OSPFv3 Extern2 3300