Owner's Manual

Chapter 18. STP | 577
NETGEAR 8800 User Manual
create stpd s2
configure stpd s2 add yellow ports all
configure stpd s2 tag 300
configure stpd s2 add red ports 1:3-1:4 emistp
enable stpd s2
RSTP 802.1w Configuration Example
Figure 57 is an example of a network with multiple STPDs that can benefit from RSTP. For
RSTP to work:
• Create an STPD.
• Configure the mode of operation for the STPD.
• Create the VLANs and assign the VLAN ID and the VLAN ports.
• Assign the carrier VLAN.
• Add the protected VLANs to the STPD.
• Configure the port link types.
• Enable STP.
Figure 57. RSTP Example
In this example, the commands configure switch A in STPD1 for rapid reconvergence. Use
the same commands to configure each switch and STPD in the network.
Sales, Personnel, Marketing
STPD 1
STPD 2
Manufacturing, Engineering, Marketing
Sales, Personnel, Manufacturing, Engineering, Marketing
Switch Y
Switch Z
Switch M
Switch B
EX_048
Switch A