Owner's Manual

Chapter 16. Network Login | 399
NETGEAR 8800 User Manual
password: <Enter the password. The switch does not display the password.>
Reenter password: <Re-enter the password. The switch does not display the
password.>
For information about specifying the destination VLAN, see the next section Specifying a
Destination VLAN on page 399.”
Note: If you do not specify a password or the keyword encrypted, you are
prompted for one.
Specifying a Destination VLAN
If you configure a local network login account with a destination VLAN, upon successful
authentication, the client transitions to the permanent, destination VLAN. You can specify the
destination VLAN when you initially create the local network login account or at a later time.
Adding VLANs when Creating a Local Network Login Account
To specify the destination VLAN when creating the local network login account, use the
following command and specify the
vlan-vsa option with the associated parameters:
create netlogin local-user <user-name> {encrypted} {<password>} {vlan-vsa
[[{tagged | untagged} [<vlan_name>] | <vlan_tag>]]} {security-profile
<security_profile>}
Where the following is true:
• tagged—Specifies that the client be added as tagged
• untagged—Specifies that the client be added as untagged
• vlan_name—Specifies the name of the destination VLAN
• vlan_tag—Specifies the VLAN ID, tag, of the destination VLAN
The following example:
• Creates a new local network login user name
• Creates a password associated with the local network login user name
• Adds the VLAN test1 as the destination VLAN
The following is a sample display from this command:
create netlogin local-user megtest vlan-vsa "test1"
password: <Enter the password. The switch does not display the password.>
Reenter password: <Re-enter the password. The switch does not display the
password.>
Adding VLANs at a Later Time
To specify the destination VLAN after you created the local network login account, use the
following command: