Owner's Manual

386 | Chapter 15. QoS
NETGEAR 8800 User Manual
• Displaying 802.1p Priority to QoS Profile Mappings on page 386
• Displaying DiffServe DSCP to QoS Profile Mappings on page 386
• Displaying Port and VLAN QoS Settings on page 386
Displaying 802.1p Priority to QoS Profile Mappings
To display the 802.1p priority to egress QoS profile mappings, use the following command:
show dot1p
Displaying DiffServe DSCP to QoS Profile Mappings
To display the DiffServ DSCP to egress QoS profile mappings, use the following commands:
show diffserv examination
Displaying Port and VLAN QoS Settings
You can display QoS settings assigned to ports or VLANs by entering the following
command:
show ports {mgmt | <port_list>} information {detail}
Note: To ensure that you display the QoS information, you must use the
detail keyword.
This command can display which QoS profile, if any, is configured.
Displaying the Rate-Limiting and Rate-Shaping Configuration
The following sections describe how to display rate-limiting and rate-shaping configuration
information:
• Displaying QoS Profile Information on page 386
• Displaying Meters on page 387
• Displaying the Traffic Queue Configuration on page 387
Displaying QoS Profile Information
You can display QoS profile information, using the following commands:
show qosprofile {ingress | egress} ports [ all | <port_list>]
show ports {mgmt | <port_list>} information {detail}
Note: You must specify ingress to view ingress rate shaping information.