Owner's Manual

298 | Chapter 12. Policy Manager
NETGEAR 8800 User Manual
Commands that use the keyword route-policy control the routes advertised or received by
the protocol. Following are examples for BGP and RIP:
configure bgp neighbor [<remoteaddr> | all] {address-family [ipv4-unicast |
ipv4-multicast]} route-policy [in | out] [none | <policy>]
configure bgp peer-group <peer-group-name> {address-family [ipv4-unicast |
ipv4-multicast]} route-policy [in |out] [none | <policy>]
configure rip vlan [<vlan-name> | all] route-policy [in | out] [<policy-name> |
none]
Other examples of commands that use route policies include:
configure ospf area <area-identifier> external-filter [<policy-map> |none]
configure ospf area <area-identifier> interarea-filter [<policy-map> | none]
configure rip vlan [<vlan-name> | all] trusted-gateway [<policy-name> | none]
To remove a routing policy, use the none option in the command.