Owner's Manual

Chapter 9. VLANs | 269
NETGEAR 8800 User Manual
create vlan ConfRoom
configure vlan ConfRoom tag 300
configure vlan ConfRoom add port 1:21-1:30
configure vlan ConfRoom add port 1:20 tagged
# Create and configure the PVLAN named Motel.
create private-vlan Motel
configure private-vlan Motel add network Main
configure private-vlan Motel add subscriber ClientConnections # isolated
subscriber VLAN
configure private-vlan "Motel" add subscriber "ConfRoom" non-isolated
loopback-port 30
configure private-vlan Motel add subscriber ConfRoom non-isolated
# If you omit the loopback-port command, the above command produces the following
error message:
# Cannot add subscriber because another subscriber vlan is already present on the
same port, assign a loopback port when adding the subscriber vlan to the private
vlan
show vlan "ConfRoom"
VLAN Interface with name ConfRoom created by user
Admin State: Enabled Tagging: 802.1Q Tag 300
Virtual router: VR-Default
IPv6: None
STPD: None
Protocol: Match all unfiltered protocols
Loopback: Disabled
NetLogin: Disabled
QosProfile: None configured
Egress Rate Limit Designated Port: None configured
Private-VLAN Name: Motel
VLAN Type in Private-VLAN: Non-Isolated Subscriber
Ports: 1:13. (Number of active ports=1)
Untag: 1:21, 1:22, 1:23, 1:24, 1:25, 1:26, 1:27,
1:28, 1:29
Tag: 1s, 2s, 20, *30L
Flags: (*) Active, (!) Disabled, (g) Load Sharing port
(b) Port blocked on the vlan, (m) Mac-Based port
(a) Egress traffic allowed for NetLogin
(u) Egress traffic unallowed for NetLogin
(t) Translate VLAN tag for Private-VLAN
(s) Private-VLAN System Port, (L) Loopback port
(e) Private-VLAN End Point Port