Owner's Manual

224 | Chapter 8. Status Monitoring and Statistics
NETGEAR 8800 User Manual
configure log filter myFilter add events all match ipaddress 3ffe::1
To configure a range of IPv6 addresses with a mask of 16, use the following command:
configure log filter myFilter add events all match ipaddress 3ffe::/16
• IPv6 scoped address
IPv6 scoped addresses consist of an IPv6 address and a VLAN. The following examples
identify a link local IPv6 address.
To configure a scoped IPv6 address, with a mask of 128 assumed, use the following
command:
configure log filter myFilter add events all match ipaddress fe80::1%Default
To configure a range of scoped IPv6 addresses with a mask of 16, use the following
command:
configure log filter myFilter add events all match ipaddress
fe80::/16%Default
To configure a scoped IPv6 address with any VLAN, use the following command:
configure log filter myFilter add events all match ipaddress fe80::/16%*
To configure any scoped IPv6 address with a specific VLAN, use the following command:
configure log filter myFilter add events all match ipaddress fe80::/0%Default
Note: In the previous example, if you specify the VLAN name, it must be a
full match; wild cards are not allowed.
The <value> depends on the parameter type specified. As an example, an event may contain
a physical port number, a source MAC address, and a destination MAC address. To allow
only those RADIUS incidents, of severity
notice and above, with a specific source MAC
address, use the following command:
configure log filter myFilter add events aaa.radius.requestInit severity notice
match source mac-address 00:01:30:23:C1:00
The string type is used to match a specific string value of an event parameter, such as a user
name. The exact string is matched with the given parameter and no regular expression is
supported.
Match Versus Strict-Match
The match and strict-match keywords control the filter behavior for those incidents with
event definition that does not contain all the parameters specified in a
configure log filter
events match
command.
This is best explained with an example. Suppose an event in the XYZ component, named
XYZ.event5, contains a physical port number, a source MAC address, but no destination