Owner's Manual

Chapter 7. PoE | 185

NETGEAR 8800 User Manual

Slot-6 XCM8848T(P) XCM8848T Operational 48 MB

MSM-A XCM88S1 Operational 0

MSM-B XCM88S1 Operational 0

Flags : M - Backplane link to Master is Active

B - Backplane link to Backup is also Active

D - Slot Disabled

I - Insufficient Power (refer to "show power budget")

You can expect to see the following log messages generated by the system after you

have attached the card:

<Warn:HAL.Card.Warning> MSM-A: Powering on mismatch card - cfg: XCM8848T actual:

XCM8848T(P)

<Warn:HAL.Card.Warning> MSM-B: Powering on mismatch card - cfg: XCM8848T actual:

XCM8848T(P)

4. Change the slot module type to include POE by executing the command 

configure slot 4 module XCM8848T (PoE).

Note: You must configure the slot as (PoE) before the power feature is

accessible or enabled.

The following output displays the results of the show slot command after this command

has been executed:

XCM8806.2 # show slot

Slots Type Configured State Ports Flags

-------------------------------------------------------------------------------

Slot-1 XCM8824F XCM8824F Operational 24 MB

Slot-2 XCM8824F Empty 24

Slot-3 XCM888F XCM888F Operational 8 MB

Slot-4 Empty 0

Slot-5 XCM8808X XCM8808X Operational 8 MB