Owner's Manual

184 | Chapter 7. PoE
NETGEAR 8800 User Manual
Adding an XCM88P Daughter Card to an Existing
Configuration
XCM8848T I/O Modules for the NETGEAR 8800 Series Switches
This section describes how to add an XCM88P daughter card to a NETGEAR 8800 switch
configuration that has already been saved without PoE capabilities.
The following output displays the results of the show slot command with slot 4 configured:
* XCM8806.2 #
* XCM8806.2 # show slot
Slots Type Configured State Ports Flags
-------------------------------------------------------------------------------
Slot-1 XCM8824F XCM8824F Operational 24 MB
Slot-2 XCM8824F Empty 24
Slot-3 XCM888F XCM888F Operational 8 MB
Slot-4 Empty 0
Slot-5 XCM8808X XCM8808X Operational 8 MB
Slot-6 XCM8848T XCM8848T Operational 48 MB
MSM-A XCM88S1 Operational 0
MSM-B XCM88S1 Operational 0
Flags : M - Backplane link to Master is Active
B - Backplane link to Backup is also Active
D - Slot Disabled
I - Insufficient Power (refer to "show power budget")
To configure a module for the PoE daughter card:
1. Remove the XCM8848T module.
2. Attach the PoE daughter card to the XCM8848T module (as described in installation
document provided with the daughter card).
3. Re-insert the XCM8848T module with the PoE daughter card attached. The following output
displays the results of the
show slot command after the card is attached:
* XCM8806.2 #
* XCM8806.2 # show slot
Slots Type Configured State Ports Flags
-------------------------------------------------------------------------------
Slot-1 XCM8824F XCM8824F Operational 24 MB
Slot-2 XCM8824F Empty 24
Slot-3 XCM888F XCM888F Operational 8 MB
Slot-4 Empty 0
Slot-5 XCM8808X XCM8808X Operational 8 MB