Owner's Manual

158 | Chapter 6. LLDP
NETGEAR 8800 User Manual
Note: See the NETGEAR 8800 Chassis Switch CLI Manual for complete
information on configuring LLDP using the CLI.
Table 19 lists the TLVs that the switch can receive, but not transmit. To receive any of these
TLVs, the port must be enabled for LLDP. After you enable LLDP receiving on the switch, all
TLVs are received (even if the LLDP MED capabilities TLV is not enabled). To display these
received messages, use the
show lldp neighbor detailed CLI command.
Mandatory TLVs
This section describes the following mandatory TLVs, which are automatically enabled after
you enable LLDP on a port:
• Chassis ID TLV on page 159
• Port ID TLV on page 159
Location ID X MED TLVs transmit only
after detecting a neighbor
transmitting MED TLVs
Extended power via MDI X Can be enabled only on a
PoE-capable port
MED TLVs transmit only
after detecting a neighbor
transmitting MED TLVs
End-of-LLDP PDU X Mandatory TLV
Table 19. Available TLVs for Reception
Name Type Comments
Hardware revision MED
Firmware revision MED
Software revision MED
Serial number MED
Manufacturer name MED
Model name MED
Asset ID MED
Table 18. Available TLVs for Transmission (Continued)
Name Included by
default
User
configurable
Repeatable Comments