Owner's Manual

Chapter 4. Managing the XCM8800 Software | 101
NETGEAR 8800 User Manual
ls memorycard
The following is sample output from this command:
-rwxr-xr-x 1 root 0 15401865 Mar 30 00:03 bd10K-11.2.0.13.xos
-rwxr-xr-x 1 root 0 10 Mar 31 09:41 test-1.pol
-rwxr-xr-x 1 root 0 10 Apr 4 09:15 test.pol
-rwxr-xr-x 1 root 0 10 Mar 31 09:41 test_1.pol
-rwxr-xr-x 1 root 0 223599 Mar 31 10:02 v11_1_3.cfg
Transferring Files to and from the Switch
TFTP allows you to transfer files to and from the switch, internal memory card, and on a
modular switch, the external memory card. This section describes the commands used to
transfer files to and from the switch.
To transfer a configuration or policy file from a TFTP server, internal memory card, or external
memory card to the switch, use the
tftp and tftp get commands:
• tftp [<host-name> | <ip-address>] {-v <vr_name>} [-g | -p] [{-l [internal-memory
<local-file-internal> | memorycard <local-file-memcard> | <local-file>} {-r <remote-file>} |
{-r <remote-file>} {-l [internal-memory <local-file-internal> | memorycard
<local-file-memcard> | <local-file>]}]
• tftp get [<host-name> | <ip-address>] {-vr <vr_name>} [{[internal-memory
<local-file-internal> | memorycard <local-file-memcard> | <local_file>} {<remote_file>} |
{<remote_file>} {[internal-memory <local-file-internal> | memorycard
<local-file-memcard> | <local_file>]}] {force-overwrite}
Where the following is true:
• host-name—Specifies the name of the remote host on the network.
• ip-address—Specifies the IP address of the TFTP server on the network.
• vr_name—Specifies the name of the virtual router.
Note: User-created VRs are supported only on the platforms listed for this
feature in Appendix A, XCM8800 Software Licenses.
• -g—Gets the specified file from the TFTP server and copies it to the local host. (This
parameter is available only on the
tftp command.)
• get—Gets the specified file from the TFTP server and copies it to the local host. (This is
part of the
tftp get command.)
• internal-memory—Specifies the internal memory card.
• local-file-internal—Specifies the name of the core dump file located on the internal
memory card.
• memorycard—Specifies the removable external compact flash memory card. (This
parameter is available only on modular switches.)