Owner's Manual

Chapter 1. Installation and Basic Configuration | 9
XAV101v2 Powerline AV 200 Adapter User Manual
Connecting a Powerline AV Ethernet Adapter to the
Router
1. Plug a Powerline AV 200 Adapter into a power outlet near your router.
Use the supplied gray Ethernet cable to connect fro
m the adapter to a LAN port on your
router so that the Powerline network can gain access to the Internet. The Power and
Ethernet LEDs on the Powerline AV 200 Adapter should turn on.
Note: It is not necessary to disconnect your router from your computer.
Figure 3.
2. Once the adapter is plugged in and power is first applied, check to see that the Power LED
is on.
3. Af
ter approximately 10 seconds, check to see that:
a. T
he Power LED is solid green.
b. T
he Powerline LED is lit.
c. T
he Ethernet LED is on or blinks.