Owner's Manual

22 | Chapter 2. Using the XAV101v2 Powerline Utility
XAV101v2 Powerline AV 200 Adapter User Manual
Setting the priority of data transfers by the type of protocol
1. S
tart the Powerline Utility and wait for the utility to detect the Powerline adapters
connected to the network.
2. On the Ad
vanced Settings tab, click the QoS arrow.
3. T
o set the traffic prioritization rule into the selected Powerline adapter device, specify the
priority in the QoS Setup section of the screen.
Figure 5.
4. Click Apply.
Note: QoS settings are applied only to the device that is selected on the
QoS screen.
These options apply only to QoS-configured business networks. IEEE 802.1p uses
prioritization bits in Layer-2 frames. Type of Service (ToS) routing uses prioritization bits in
Layer-3 IP packets. The deprecated ToS values range from 0 to 7.