Quick Reference Guide

RangeMax NEXT Wireless Router Model WNR854T Reference Manual
2-8 Wireless Configuration
v1.0, 2006-04
• Manual method. These values are not case sensitive. For 64-bit WEP, enter 10 hex
digits (any combination of 0-9 or a-f). For 128-bit WEP, enter 26 hex digits.
Key 1: ___________________________________
Key 2: ___________________________________
Key 3: ___________________________________
Key 4: ___________________________________
• If WPA-PSK or WPA2-PSK Authentication is Used:
– Passphrase: ______________________________
These characters are case sensitive.
Enter a word or group of printable characters. When you use WPA-PSK, the other devices
in the network will not connect unless they are set to WPA-PSK as well and are configured
with the correct Passphrase. Similarly, when you use WPA2-PSK, the other devices in the
network will not connect unless they are set to WPA2-PSK and are configured with the
correct Passphrase.
Use the procedures described in the following sections to configure the WNR854T. Store this
information in a safe place.
Default Factory Settings
When you first receive your WNR854T, the default factory settings are in effect as shown below.
You can restore these defaults with the Factory Default Restore button on the rear panel. After you
install the RangeMax NEXT Wireless Router, use the procedures below to customize any of the
settings to better meet your networking needs.
FEATURE DEFAULT FACTORY SETTINGS
Wireless Router Radio Enabled
Wireless Access List (MAC Filtering) All wireless stations allowed
SSID broadcast Enabled
SSID NETGEAR
802.11b/g/n RF Channel 6
Mode 802.11b/g/Next
Authentication Type Automatic
WEP Disabled
DHCP Server Enabled
DHCP range 192.168.1.2 to 192.168.1.254