Quick Start Manual

Configuring Your Wireless Network 27

• The router will have generated an SSID, implemented WPA/WPA2 wireless security

(including a PSK security password), and transmitted these settings to the client; the client

now shares the same security settings as the router.

• A “Success” message should display on your client device.

After configuring wireless security on your router, either by using “Using Push 'N' Connect (WPS)

to Configure Your Wireless Network” on page 25, or by setting up wireless security manually (see

“Setting Your SSID and Wireless Security Manually” on page 24), you can add additional clients

to your network by using the Push 'N' Connect button or by logging in to your wireless router.

To add additional clients to your network using the WPS button:

Press the WPS push-button on the router.

2. The router will attempt to communicate with the client; you have 2 minutes to enable WPS

from the client device using the client’s WPS networking utility.

• If no connection is detected:

– The client device networking utility screen should display a message confirming that

WPS did not establish a connection with the wireless router.

– No security settings were transmitted or configured on the client device.

• If a connection is established:

– The client device networking utility screen should display a message confirming that

the wireless client was successfully added to your wireless network.

– The wireless router’s SSID and wireless security settings were successfully

transmitted to the client; the client now shares the same security settings as the router.

To add additional clients to your network using WPS from the router menu:

http://www.routerlogin.com in the address field of your browser. Enter the default user name

of admin and default password of password. Click Enter.

2. On the router main menu, select Add a WPS Client. The Add WPS Client wizard screen

displays. Click Next.