Quick Reference Guide

Advanced Configuration
129
ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
Figure 75.
g. Specify the settings as explained in the following table:
Table 38. Wireless signal repeating profile and authentication settings
Setting Description
Profile Definition
Profile Name Enter a profile name that is easy to rememb
er. The default names for the four
security profiles are NETGEAR-WDS-1, NETGEAR-WDS-2,
NETGEAR-WDS-3, and NETGEAR-WDS-4.
Remote MAC Address Enter the MAC address of the remote wireless access point (the MAC
addres
s of AP1 or AP3 in Figure 73 on page 127).
Authentication Settings
Network Authentication
and
Data Encryption
From the Network Authentication drop-down list, select Open
System,
WPA-PSK, or WPA2-PSK. Your selection determines the options that the
Data Encryption drop-down list provides, and whether the WPA Passphrase
(Network Key) field displays.
Open System Although you can use the bridge communication without any
auth
entication and encryption, NETGEAR recommends that
you use WEP if you do select an open system. From the
Data Encryption drop-down list, select one of the following:
• None. No authen
ti
cation and encryption.
• 64-bit WEP. S
tandard WEP encryption, using 40/64-bit
encryption.
• 128-bit WEP. S
tandard WEP encryption, using
104/128-bit encryption.
• 152-bit WEP. Pro
prietary WEP encryption mode, using
128+24 bit encryption. This mode functions only with
other wireless stations that support this mode.