Quick Reference Guide

Advanced Configuration
122
ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
h. Click Apply to save your security profile settings. The Bridging screen displays
again.
i. If the correct profile name and security
option are displayed in the table, select the
check box in the Enable column.
j. Click Apply on the Bridg
ing screen to save your point-to-point bridge settings.
2. Configure a second wireless access point (AP2) on LAN Segment 2 (see Figure 67
on
page 120) in point-to-point bridge mode.
AP1 needs to have AP2’s MAC address in its Remote MAC Address field, and AP2 needs
to have AP1’
s MAC address in its Remote MAC Address field.
3. V
erify the following settings for both wireless access points:
• Both wireless access p
oints are configured to operate in the same LAN network
address range as the LAN devices.
• Both wireless access points us
e the same channel, authentication mode, and security
settings.
4. V
erify connectivity across the LAN 1 and LAN 2.
Network
Authentication and
Data Encryption
(continued)
Open System Although you can use the bridge communication without any
authentication and encryption, NETGEAR recommends that
you use WEP if you do select an open system. From the Data
Encryption drop-down list, select one of the following:
• None. No authe
nti
cation and encryption.
• 64-bit WEP. Standard WEP encryption, using 40/64-bit
encryption.
• 128-bit WEP. S
tandard WEP encryption, using
104/128-bit encryption.
• 152-bit WEP.
Proprietary WEP encryption mode, using
128+24 bit encryption. This mode functions only with
other wireless stations that support this mode.
WPA-PSK TKIP (Temporal Key Integrity Protocol) is the standard
e
ncryption method used with WPA-PSK and the only
selection possible from the Data Encryption drop-down list.
In the WPA Passphrase (Network
Key) field, enter
a
passphrase. The passphrase length needs to be between
8 and 63 characters (inclusive).
WPA2-PSK AES (Advanced En
cryption Standard) is the standard
encryption method used with WPA2-PSK and the only
selection possible from the Data Encryption drop-down list.
In the WPA Passphrase (Network Key) field, enter
a
passphrase. The passphrase length needs to be between
8 and 63 characters (inclusive).
Note: NETGEAR recommends WPA2-PSK authentication
with
AES encryption if you want to use the 11n rates and
speed.
Table 36. Point-to-point bridge profile and authentication settings (continued)
Setting Description