Quick Reference Guide

Introduction
12
ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
Top Panel
The LEDs of the wireless access point are described in the following figure and table:
Figure 1.
Table 1. Top panel LEDs
Item LED Description
1 Power/Test Off Power is off.
On (green) Power is on.
Amber, then blinking
green
A self-te
st is running or software is being loaded.
During startup, the LED is first steady amber, then
goes off, and then blinks green before turning steady
green after about 45 seconds. If after 1 minute the
LE
D remains amber or continues to blink green, it
indicates a system fault.
2 Active Off No Ethernet traffic is detected, or no link is detected.
On or blinking (green) Ethernet traffic is detected.
3 LAN 1 Off 10 Mbps or no link is detected on LAN port 1.
Amber 10/100 Mbps link is detected on LAN port 1.
Green 1000 Mbps link is detected on LAN port 1.
4 LAN 2 Off 10 Mbps or no link is detected on LAN port 2.
Amber 10/100 Mbps link is detected on LAN port 2.
Green 1000 Mbps link is detected on LAN port 2.
1
23
4
5
6