Quick Reference Guide

Advanced Configuration
114
ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
• EtherType. Indicates the EtherType field in Ethernet-II frame header.
• Source MAC. Indi
cates the source MAC address in Ethernet-II frame header.
• Destination MAC. Indicates
the destination MAC address in Ethernet-II frame header.
• Source IP.
Indicates the source IP address in the IP header.
• Destination IP. Indicates the
destination IP address in the IP header.
• Source port. Indicates the source port
number in the port header.
• Destination port. Indicates the
destination port number in the port header.
For each classification in a QoS policy, you can con
figure rate limiting by specifying the
maximum bit rate and maximum burst rate. Packets that exceed the maximum bit rate are
retained in the traffic queue and are processed when transmission falls below the maximum
bit rate again. You can also configure the overall maximum bit rate and maximum burst rate
for the entire wireless interface.
You can configure up to eight QoS policies.
 To configure a new QoS policy:
1. Select Configuration
> Wireless > Advanced > QoS Policies. The advanced QoS
Policies screen displays:
Figure 66.
2. Optional: To configure the QoS Policies screen for the 802.11a/na modes, click the
802.11a/na tab.
3. From the Create Policy drop-down list, select NE
W. If you have not created any QoS
policies, NEW is the only selection possible.
4. In the Policy Name field, enter a name for the new QoS policy.