Owner's Manual

Wireless Point-to-Point Configuration
Access Point 1
Access Point 2
• In each Access Point, in the Wireless
Bridge Page, enable Wireless
Bridinging and Repeating and select
the option for Wireless Point-to-
Point Bridge
• Make note of the following:
MAC Adress of Access Point 1:
MAC Adress of Access Point 2:
Click on the Edit button at the bottom of the screen to change the details of the profile you have
enabled:
Access Point 1
• Enter the MAC Adress of Access
Point 2 ( ) in the Remote MAC
Address field.
• Enter your Network Authentication
details. Make sure the settings you
use here are set identically in both
Access Points.
Access Point 2
• Enter the MAC Adress of Access
Point 1 ( ) in the Remote MAC
Address field.
• Enter your Network Authentication
details. Make sure the settings you
use here are set identically in both
Access Points.