User manual
Table Of Contents
- ProSafe Wireless-N Access Point WNAP210
- Contents
- 1. Getting Started
- 2. Installation and Configuration
- Wireless Equipment Placement and Range Guidelines
- Prepare to Install the Access Point
- Connect to the Access Point
- Log In to the Access Point
- Configure LAN Settings
- Set Basic IP Options
- Set Up and Test Basic Wireless Connectivity
- QoS Settings
- Deploy the Access Point
- Wireless Security Options
- Security Profiles
- Restrict Wireless Access by MAC Address
- 3. Management
- 4. Monitoring
- 5. Advanced Configuration
- 6. Troubleshooting and Debugging
- A. Supplemental Information
- B. Command Line Reference
- C. Notification of Compliance
- Index
Advanced Configuration
53
ProSafe Wireless-N Access Point WNAP210
Point-to-Point Bridge
LAN Segment 2
LAN Segment 1
Hub or switch
AP 2
APs in point-to-point bridge mode
AP 1
Router
Figure 3. Point-to-point bridge mode
To configure a point-to-point bridge:
1. Select Configuration > Wireless Bridge > Bridging and Repeating. The Bridging and
Repeating screen displays.
2. Select the Enable Wireless Bridging and Repeating check box. This allows you to select
a bridging mode.
3. Select Wireless Point-to-Point Bridge, and click Apply.
4. Configure the first access point (AP 1) on LAN Segment 1 in point-to-point bridge mode.