Quick Reference Guide
Table Of Contents
- ProSafe Wireless-N Access Point WNAP210 Reference Manual
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Wireless Equipment Placement and Range Guidelines
- Understanding WNAP210 Wireless Security Options
- Installing the WNAP210 Wireless Access Point
- Deploying the Access Point
- Mounting the Access Point Using the Wall Mount Kit (Optional)
- Setting Basic IP Options
- Wireless Settings
- Setting Up and Testing Basic Wireless Connectivity
- Understanding Security Profiles
- Chapter 3 Management
- Remote Management
- Remote Console
- Upgrading the Wireless Access Point Software
- Managing the Configuration File
- Restoring the WNAP210 to the Factory Default Settings
- Changing the Administrator Password
- Enabling the Syslog Server
- Using Activity Log Information
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Viewing Available Wireless Station Statistics
- Enabling Rogue AP Detection
- Viewing and Saving AP Lists
- Chapter 4 Advanced Configuration
- Chapter 5 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN LED does not light up.
- The Ethernet LAN LED is not lit.
- I cannot access the Internet or the LAN with a wireless- capable computer.
- I cannot connect to the WNAP210 to configure it.
- When I enter a URL or IP address, I get a time-out error.
- Using the Restore Factory Settings Button to Restore Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Appendix C Command Line Reference
- Index
ProSafe Wireless-N Access Point WNAP210 Reference Manual
5-4 Troubleshooting and Debugging
v1.0 March 2009
Using the Restore Factory Settings Button to Restore
Default Settings
The Restore factory settings button (see “Rear Panel” on page 1-7) has two functions:
• Reboot. When this button is pressed and released quickly, the WNAP210 reboots (restarts).
• Reset to factory defaults. This button can also be used to clear all data and restore all settings
to the factory default values.
To clear all data and restore the factory default values:
1. Power off the WNAP210, and power it back on.
2. Use something with a small point, such as a pen, to press the restore settings button in and hold
it in for at least 5 seconds.
3. Release the restore settings button.
The factory default configuration has now been restored, and the WNAP210 is ready for use.