Quick Start Manual

20
5. I have enabled a wireless MAC filter (wireless access control – ACL)
on my router. What should I do when installing the WN3500RP?
The wireless device MAC address is translated to another MAC address
when the wireless device connects to the WN3500RP. If your router MAC
filter is enabled, the wireless device will not be able to get the IP address
from the WN3500RP. To allow this wireless device to access the
Internet, you must add the translated MAC address into the router.
To get the translated MAC address:
a. Disable the MAC filter on your router.
b. Power on the WN3500RP and connect all of your wireless
devices to the WN3500RP.
c. Make sure that the Link Rate LED remains lit.
d. Log in to your router and check the attached devices on the
Attached Devices screen. Add any MAC addresses that begin
with 02:0F:B5 into your router’s MAC filter table.