Manualshelf

Installation Guide

ManualsBrandsNetgear ManualsWirelessNetgear WN1000RP
12345678910
8
Connect with WPS
Wi-Fi Protected Setup (WPS) lets you join a secure WiFi network
without typing the network name and password. The WPS button is a
physical button on the router or access point.
WPS does not support WEP network security. If you are using WEP
security, see Connect with NETGEAR genie Smart Setup on page 10.
To connect with WPS:
1. Press the WPS button on the WiFi booster.
2. Within two minutes, press the WPS button on your WiFi router,
gateway, or access point.
The Link Rate LED on your WiFi booster lights, and the
WiFi booster is connected to your existing WiFi network.
Note: If the Link Rate LED does not light, try again. If it still does
not light, see Connect with NETGEAR genie Smart Setup on
page 10.