Installation Guide

Install the WiFi Booster

Place the WiFi booster, apply power, and connect it to your WiFi

network.

Place the WiFi Booster

1. Place your WiFi booster in the same room as your WiFi router.

Note: Proximity to the WiFi router is required only during the

initial setup process.

2. Plug the WiFi booster into an electrical outlet and wait one minute.

The Status LED lights green. If the Status LED does not

light, press the On/Off button.

Connect the WiFi Booster

To extend the range of your WiFi network, you must connect the WiFi

booster to your existing WiFi network. You can do this in one of two

ways:

• Connect with WPS. For more information, see Connect with

WPS on page 8.

• Connect with genie Smart Setup. For more information, see

Connect with NETGEAR genie Smart Setup on page 10.