Reference Manual

Maintenance
53
ProSafe 16 AP Wireless Management System WMS5316
1. Select the group of access points to be rebooted using the tabs. Access points not
assigned to a specific group belong to Group 1.
2. Select the Yes radio button.
3. Click Apply to reboot the access points in the selected group.
SNMP
You can use SNMP for the wireless management system or advanced SNMP for access
point groups. Enable SNMP to allow the SNMP network management software, such as HP
OpenView, to monitor the wireless management system by using SNMPv1/v2 protocol.
SNMP for the Wireless Management System
On the Maintenance tab, select Remote Management > SNMP:
• SNMP: Select this check box to enable SNMP for the wireless management system.
• Read-Only Community Name: The community string that allows the SNMP manager to
read the WMS5316 MIB objects.
• Read-Write Community Name: The community string that allows the SNMP manager to
read and write the WMS5316 MIB objects.
• Trap Community Name: The community name that is associated with the IP address to
receive traps.
• IP address to Receive Traps: The IP address at which the SNMP manager receives traps
sent from the wireless management system.
• Trap Port: The port on which the SNMP manager receives traps sent from the wireless
management system. The default setting is port 162.
• SNMP Manager IP: Restrict access to the specified SNMP manager for doing SNMP
v1/v2. Set this to 255.255.255.255 to allow any SNMP manager to access.
When you are finished making changes, click Apply to save your settings.