Manualshelf

Reference Manual

ManualsBrandsNetgear ManualsWirelessNetgear WMS5316
11121314151617181920
Access Point Discovery
14
ProSafe 16 AP Wireless Management System WMS5316
Auto Discovery
Use Auto Discovery if the wireless management system and all access points on the LAN are
in the same IP subnet. The process of Auto Discovery depends on how your access points
are configured.
To use Auto Discovery:
1. On the Configuration tab select Access Point Discovery.
2. Click Search.
• The wireless management system searches for NETGEAR products on the LAN
based on MAC address, and then identifies which are access points.
• A list of the access points located through discovery is displayed on the screen.
3. Check the discovery results to make sure that all the access points are listed. See Discovery
Results on page 15.
4. Add the access points as described in Adding Access Points on page 16.